2 pr of Xover boards almost done.... *PIC*

[Wolf]

http://i18.photobucket.com/albums/b117/wolf_teeth_speaker/3CR/100_3088.jpg

Provided Link: Wolf's 'Bucket!....... (http://s18.photobucket.com/albums/b117/wolf_teeth_speaker/)


I have pictured the control-network for the "3CR-Ti"/W4-1337S running full-range. In case you are wondering, the ASC 20uF (18.9uF) caps were from All-Electronics, and I got 4 of them before they apparently ran out. They are a very nice poly cap. 400VDC/10%. It's on pegboard that I painted red. Size is 4" x 5".

Xover boards for a set of "Deuterium" Def Tech 5.25"/Dayton Silky 2-ways (4" x 4"):

<A HREF="http://i18.photobucket.com/albums/b117/wolf_teeth_speaker/simulatedXover.jpg">http://i18.photobucket.com/albums/b117/wolf_teeth_speaker/simulatedXover.jpg</A>

<A HREF="http://i18.photobucket.com/albums/b117/wolf_teeth_speaker/100_3076.jpg">http://i18.photobucket.com/albums/b117/wolf_teeth_speaker/100_3076.jpg</A>

I have to solder up all 4 boards, but assembly is finished. All they need is a set of connecting leads. I may make some standoffs and plexi to complete the "3CR-Ti" Xover boards. Red LED's edge-lighting would be cool against the red boards...nothing too fancy, as I just did that sorta thing with the Scandivifia Xovers.
Later,
Wolf

[Wolf]

http://i18.photobucket.com/albums/b117/wolf_teeth_speaker/3CR/3CR-TI_xover.jpg


I felt it necessary to highlight the DCR of the coils, and put my used values in the schem. The .2mH coil's DCR is included in the 6 ohm resistor. The .3mH is the best-fit, IMO. I also inverted the colors on the graphic to clean it up a little. They just look more like blueprints that way....
Later,
Wolf