Dual-Reflex version of Lou's Amethyst?

[Thezeek]

Just looking for input on this. Lou C's Amethyst Micros but put in a Dual-Reflex box with slot ports, one on the top, bottom and a tube inside. I might bump up the volume of the box alittle. Might call it the Lou Wolf Express non-Ti Bandits.

Thanks.

[Wolf]

Just looking for input on this. Lou C's Amethyst Micros but put in a Dual-Reflex box with slot ports, one on the top, bottom and a tube inside. I might bump up the volume of the box alittle. Might call it the Lou Wolf Express non-Ti Bandits.

Thanks.

Well.... You have to have EXACTLY the same vents for all three in the DCR. This means the inner should also be a slot-vent of the same size. I think the W4-1052SD will work well in that, and I did consider it for the 3CR gamut. I would only change the volume for the amount of bracing and walls you put in.

If I recall correctly, the port in those was a 1-1.5", so you could make it smaller for a single per chamber. If you want to remodel it, model the same volume for dual-ports, and then add for bracing used, and not for the 3rd port you install.

I had fill in both chambers of the DCR's I built. If you have more questions, just ask.
Later,
Wolf

[Thezeek]

Thanks for the input on the internal vent Wolf. You may have saved me alot of problems.

[Wolf]

Thanks for the input on the internal vent Wolf. You may have saved me alot of problems.

You're welcome!
Wolf