linwin3000
05-12-2011, 06:45 PM
I`ve been using the Fitzpatrick version of LMP, actually SD-LMP for 11 years now and I feel the need to upgrade to some kind of design software that has a c/o optimizer. SD-LMP has worked well enough but does not optimize and is not very intuitive. Box volume, port design, etc. is not needed, and I have a WT-3 to do impedance, so I need a good full range integrated piece of software that especially homes in on c/o development. A good modeling program would be quite fine, perhaps along the lines of Calsod or??? Does anyone have suggestions? Oh yes, budget limited to about 200.00 or so.
Thanks
Richard
Thanks
Richard