View Full Version : Sent in an OmniMic for repairs....will the new one have a calibration file?
07-09-2012, 03:59 PM
The thread title is pretty much the question.
I sent in my OmniMic for service (it refused to make USB connections) and I forgot to inquire about the calibration service when I spoke to customer service.
It was RA#: 36234 if that helps.
07-09-2012, 09:05 PM
if its the new version, it should be available on the dayton audio sight. if its the old one, then use the same number you used when you bought it.
07-18-2012, 06:01 PM
You guys ROCK! I got the revised V2 unit....and the problem I had should never happen again thanks to the full size USB port.
Wall Street could take lessons from PE on how to run a business. Thanks guys!
Now on to grab FS graphs for an Avid 102 woofer....10" 2 ways, always a challenge.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.