Announcement

Collapse
1 of 2 < >

Midwest Audio Fest

It’s that time audio enthusiasts!

Registration for the 2019 Speaker Design Competition is now open! Visit midwestaudiofest.com for details and to list your speaker project.
We are excited to see all returning participants, and look forward to meeting some new designers this year, as well!

Be sure your plans include a visit to the Parts Express Tent Sale for the lowest prices of the year, and the Audio Swap Meet where you can buy and trade with other audio fans.

We hope to see you this summer!

Vivian and Jill
2 of 2 < >

Midwest Audio Fest

It’s that time audio enthusiasts! Registration for the 2019 Speaker Design Competition is now open! Visit midwestaudiofest.com for details and to list your speaker project. We are excited to see all returning participants, and look forward to meeting some new designers this year, as well! Be sure your plans include a visit to the Parts Express Tent Sale for the lowest prices of the year, and the Audio Swap Meet where you can buy and trade with other audio fans. We hope to see you this summer! Vivian and Jill
See more
See less

Switch from OmniMic to UMM-6, high and low end issues

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Switch from OmniMic to UMM-6, high and low end issues

    I was using an OmniMic USB microphone with REW software, I returned the OmniMic setup for another reason and instead purchased a UMM-6 for use with the REW program. I loaded the proper calibration file, and now all my readings are showing a drop off below 100HZ and above 10kHz that weren't there before. I've tried swapping the mid-stream gear, amp/source, and the result is the same. Any idea why the readings would be so far off?

    I'm using REW on a MacBook Pro with a UMM-6.
    The output from the laptop is either built in analog or a separate Compact USB DAC. The results are the same.

    Thanks

  • #2
    Found the problem! The input setting was set to "Default" and not UMM-6. Once I switched to UMM-6 it started using the calibration profile for the mic. Response works great now. FYI

    Comment


    • #3
      Ugh - Having this problem again. Input is set to the mic and still having huge drop off after 10 kHz.

      Comment

      Working...
      X