Announcement

Collapse
No announcement yet.

Calibration files

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Calibration files

    Can anyone tell me where to look for the mic calibration files? The instructions say what to download but not where to find it. Tech support was closed when I tried to call, and searches on PE's site and Dayton Audio site didn't get me anywhere.

  • #2
    They're available on the product page at Dayton's website. Just enter your serial number.

    EMM-6:
    http://www.daytonaudio.com/index.php...icrophone.html

    UMM-6:
    http://www.daytonaudio.com/index.php...icrophone.html

    Omnimic:
    http://www.daytonaudio.com/index.php...nt-system.html
    Don't waste your money on a new set of speakers, You get more mileage from a cheap pair of sneakers. Next phase, new wave, dance craze, anyways it's still rock and roll to me!

    Comment


    • #3
      Thank you sir!

      Comment


      • #4
        It turns out that I have both the OmniMic and EMM-6 mics available, which should I use for OmniMic system?

        Comment


        • #5
          The Omnimic software only works with the Omnimic. You may use the Omnimic with other software however.
          Don't waste your money on a new set of speakers, You get more mileage from a cheap pair of sneakers. Next phase, new wave, dance craze, anyways it's still rock and roll to me!

          Comment


          • #6
            Thanks again.

            Comment

            Working...
            X