Built another pair of 2.5way Overnights for a buddy at works', father in law. Everything's finished except for the feet so I decided to bring them in and give everything the once over.
Measurements were taken with REW @1 meter, on the back patio. They measure pretty close to each other. 1/48th smoothing.
DATS shows this. Nice little wrinkle @180hz. and I need to adjust the box tuning a little .
Without much time listening things sounded ok till we got to Madonna's Vogue. There are these bamboo sounding percussion pieces that are outside the right speaker, then her voice comes in outside the left speaker. Her voice didn't. Percussion was outside the right speaker, and her voice was instead in between the speakers. Not good. Reversed the channels and her voice was outside the right and the percussion was between the speakers.
Measurements show I have a little work to do, but not that bad for a beginner.
So what went wrong? Something to do with phase? Would that not show up on these plots?
... and is there an easy way to rotate that pic?
Comment