Announcement

Collapse

Midwest Audio Fest

It’s that time audio enthusiasts! Registration for the 2019 Speaker Design Competition is now open! Visit midwestaudiofest.com for details and to list your speaker project. We are excited to see all returning participants, and look forward to meeting some new designers this year, as well! Be sure your plans include a visit to the Parts Express Tent Sale for the lowest prices of the year, and the Audio Swap Meet where you can buy and trade with other audio fans. We hope to see you this summer! Vivian and Jill
See more
See less

How much clearance for bottom port

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • hobbyhands
    started a topic How much clearance for bottom port

    How much clearance for bottom port

    So my simulation on my latest project are saying I need 8.25" port length. My box is not that deep. I have three choices as I see it.

    1. L shaped port
    2. Port on the top
    3. Port on the bottom
    How much clearance would I need for the bottom?

  • fpitas
    replied
    Originally posted by AEIOU View Post

    POLK Audio Power Port.
    Thanks! Whatever the pros and cons of bottom porting, I've always liked the look of that thing.

    Leave a comment:


  • AEIOU
    replied
    Originally posted by fpitas View Post
    . . . . cone-shaped aerodynamic device that I've seen used.
    POLK Audio Power Port.

    Leave a comment:


  • jhollander
    replied
    Originally posted by PWR RYD View Post
    If you had a port with a 2" internal diameter then you would want to have 2" tall feet on the bottom of your enclosure.
    To use the bottom of the cabinet and stand top as the port I calculated the same area as the port, like a slot port and ended up with 1/2 inch feet for my 1-3/8 inch port tube. That was probably a bit higher than needed, but I was able to adjust the inside port tube to get the tuning I wanted.

    Leave a comment:


  • fpitas
    replied
    I've always wanted to do bottom ported, just so I could use that cool cone-shaped aerodynamic device that I've seen used.

    Leave a comment:


  • PWR RYD
    replied
    If you had a port with a 2" internal diameter then you would want to have 2" tall feet on the bottom of your enclosure.

    Leave a comment:


  • hobbyhands
    replied
    So let me clarify. Not internally but externally. So if the port opening were on the bottom of the box.

    Leave a comment:


  • jhollander
    replied
    The proximity of the port to the cabinet wall and floor can increase the effective length of the port. If you have the ability to measure the tuning you can make adjustments as you go. I also did a project where the port exited the bottom of the cabinet and I used the space under the cabinet to extend the length of the port.

    Leave a comment:


  • Chris Roemer
    replied
    I put some screen around the bottom to make it easier to dump out stuff that "falls" in there.

    Leave a comment:


  • wogg
    replied
    Approximately the diameter of the port. You can go smaller, but you're tuning frequency will be affected a bit.

    Leave a comment:

Working...
X