Announcement

Collapse
No announcement yet.

T/S Parameters and BassBox 6 Pro

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cardsin2005
    replied
    Thank you very much for the answers. I was going crazy trying to search such a question.

    Leave a comment:


  • Chris Roemer
    replied
    anyway (purty sure) when box modeling, DVC arrangements will have the same Qts values whether wired in series or parallel. If you drive only a single coil, the Q values double (or is it halve?) approximately. Double I think.

    Leave a comment:


  • devnull
    replied
    1) They are measured in series, there's a note somewhere on the PE webpage. Don't know if it's on the specification PDF
    2) If you measured them series then put them in the series column

    Leave a comment:


  • Cardsin2005
    started a topic T/S Parameters and BassBox 6 Pro

    T/S Parameters and BassBox 6 Pro

    Question #1
    I have a question that I have been trying to answer for the past few days. When I am inputting T/S parameters for a DVC sub into BassBox 6 (or any other software) I am never quite sure how the QES and QTS numbers are published in the woofer spec sheets. Are T/S parameters published with the QES and QTS measured from just a single coil, or are they measured in parallel, or are they measured in series. I know the measurement of the QES or QTS should be about half the individual coil measurement when wired in parallel or series.

    Question #2
    I am measuring a DVC woofer with a Dayton DATS to derive the T/S parameters. I have the woofer coils wired in series when measured. When I put the T/S numbers into BassBox 6 do I put the electrical and electromechanical parameters into the series column?
Working...
X