Announcement

Collapse
No announcement yet.

Circle Jig

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Circle Jig

    https://www.youtube.com/watch?v=YQdN...em-uploademail

    There are may such videos on YouTube - but his instructions were great and I liked the overall design.

    Maybe I take a stab at it.

  • #2
    That's a brilliant design!
    Carbon13

    Comment


    • #3
      I like the baseplate bearing idea.
      Wolf
      "Wolf, you shall now be known as "King of the Zip ties." -Pete00t
      "Wolf and speakers equivalent to Picasso and 'Blue'" -dantheman
      "He is a true ambassador for this forum and speaker DIY in general." -Ed Froste
      "We're all in this together, so keep your stick on the ice!" - Red Green aka Steve Smith

      *InDIYana event website*

      Photobucket pages:
      http://photobucket.com/Wolf-Speakers_and_more

      My blog/writeups/thoughts here at PE:
      http://techtalk.parts-express.com/blog.php?u=4102

      Comment


      • #4
        yeah, no more tangles!

        Comment


        • #5
          It is a very good design. I would modify it a bit by making a mark across the slide at the center of the pin, and another on either side of the center of the router hole. It would make setting the radius a bit easier.
          It is estimated that one percent of the general population are psychopaths - New Criminologist: Understanding Psychopaths

          Comment


          • #6
            Yes that is great!

            I like his last point, that you don’t need to switch base plates and screw anything down.

            Comment


            • #7
              Nicely conceived! I have been looking for a tangle-free, dust-hose friendly solution for a long time.
              Bill Schneider
              -+-+-+-+-
              www.afterness.com/audio

              Comment


              • #8
                Very nice. Should I break my Jasper Jig, this will be the replacement.

                Comment


                • #9
                  Why are these not commercially available right now?

                  I need one or two already . . .

                  Comment


                  • #10
                    Better than running in circles!

                    A bit surprised the cabinetmaker didn't whip-up some cutouts and disks with the drill press and wing circle cutter.
                    They are fast/easy/accurate up to 8".

                    Comment

                    Working...
                    X