I was going to suggest the same possible issue.
It shouldn't be difficult to wire up a simple double pull double throw switch (On - Off...
Blenton
Midrange Member
Last Activity: 02-16-2020, 10:40 PM
Joined: 01-29-2011
Location: South East Idaho
-
Thanks. I happened to be looking at a refurb DX975 thinking it was new, so the price difference is much more than the $30 I thought I was seeing. The... -
Thanks for setting me straight. I was trying to dust off the mothballs covering what I had read about class d switching filtering in other posts. That’s...Leave a comment:
-
Pioneer definitely sells the same gear under a different label for different markets. Usually they are the exact same equipment and I don't really care...Leave a comment:
-
Amp Gurus - Opinions, please..
Given these two PCB's, what do you surmise the actual difference is between them? They are rated for the same power, but one is touted as as having better...
-
Ya, definitely. YMMV. I wouldn't touch any Irwin blades but the Marples. And now that I think of it, i'm pretty sure they switch MFG facilities a few...Leave a comment:
-
My Forrest WWII sits on the shelf feeling lonely and unloved. I purchased it several years ago when I wanted to up my blade game and found it's cuts...Leave a comment:
-
I know this question wasn't directed at me, but start with a few drops of dye. Seriously. Measure in drops. I think I once used an entire ounce in a quart...Last edited by Blenton; 02-05-2020, 01:42 AM.Leave a comment:
-
But are the pots linear or logarithmic....?
I'm sure that somebody more knowledgable about small electronics parts than I am can tell you...Leave a comment:
-
I agree. Aniline dyes work great. I often spike a stain with some extra dye when I want a little more potency from it. Straight black dye is too potent,...Leave a comment:
-
Yes. I can't say that I like it so much. It adds an authentic grunge to light lumber, but isn't stable or very repeatable. It's not black but more...Leave a comment:
-
That is what I was about to suggest. I, too, have done this.
I havent had had to use an art clean box with my Crown XLS but noticed what...Leave a comment:
-
Master Bar and Super Plate Alignment System for the table saw, a straight edge, and a few pieces of scrap. Uses a machinist's dial and high precision...Leave a comment:
-
Maybe I should turn this in to a vote since I can't decide what to do. I might just have to build a couple of these designs and see what I like best....Leave a comment:
-
...Leave a comment:
-
Peerless STW-350F Potential Alignments
Per other discussions on the Peerless STW-350F, I decided to post some of the possible alignments for this amazing driver. My models are by no means...
-
Count me in! I’m interested in what you find out....Leave a comment:
-
Billet touched on some of the things I would bring up in a discussion on that top octave above 10k. I have retained much of my hearing in that range and...Leave a comment:
-
To the OP question: I typically don’t consider the room when designing a sub and here’s why: my room changes. And my subs don’t always stay in my...Leave a comment:
-
With the type of egregious power that the KRL4000 puts out, you might be temped to put it in a sealed box with lots of boost. This will work fine, except...Leave a comment:
No activity results to display
Leave a comment: