shrub0
New Member
Last Activity: 02-20-2020, 04:37 PM
Joined: 03-03-2012
Location:
-
John, do you remember what size the pvc mounting blocks are? -
Ok John, I finally understand, thanks for your patience. So when using the relief cut jig do I just line it up so that the saw will just fully cut the...Leave a comment:
-
Or is the 22 degree bevel shown in this picture in pink....
Leave a comment:
-
Ok I think the source of my confusion is this picture. Should'nt we be cutting the purple line at 22 degress?
...Leave a comment:
-
Ok, but in response to my first question the saw is set at 45 when using the first jig?Leave a comment:
-
I appreciate your help John.
I think what I was confused with is the bevel angle of the saw when using the side panel cutting jig. It should...Leave a comment:
-
Thanks for the quick reply John. What size are the side boards before going into the 1st right angle jig?
Is it possible to cut a 22 degree bevel...Leave a comment:
-
John,
I started my build of your design. So far I've got the top and bottom parts of the horn cut.
One question, on page 16 of the...Leave a comment:
No activity results to display
Leave a comment: