Hi Neil,
I downloaded the IR protocol analyzer you suggested and confirmed that it uses the NEC 32-bit protocol. I connected an encoder to an arduino...
silverD
Been Around Awhile
Last Activity: Today, 05:31 PM
Joined: 04-07-2014
Location: Minneapolis
-
Excellent work and suggestion Neil....Leave a comment:
-
Thanks everyone. Yes, the burnt ends do give them a neat contrast. The laser cutter has an exhaust fan that pulls away most of the smell/smoke when...Leave a comment:
-
Hi mlau, I'd like to take credit for the article and YouTube video, but it was your post that inspired me to look into this. I thought it would be neat...Leave a comment:
-
Thanks for digging into this Neil. I tried an encoder and a pot and came to a similar conclusion. Keep us posted on the sound quality.Leave a comment:
-
Keep us posted on how they turn out djg.Leave a comment:
-
Has your board come in Neil?...Leave a comment:
-
Looking good! Nice work.Leave a comment:
-
Yep, I think it sounds good. Audio Science Review says otherwise...Leave a comment:
-
I just built mine so I can't speak to reliability. I used 2 125ASX2 in BTL for monoblocks. They need a preamp with low output impedance based on reviews...Leave a comment:
-
Yeah it is odd. The image of the board has the pins numbered so you can cross-reference the two. Same pin count on the chip, but different model number...Leave a comment:
-
I've used the 125ASX2. What info are you after?Leave a comment:
-
Hi Mike,
I'm not really trying to improve low end response, just having fun messing around with a sonos speaker and sharing what I come across....Leave a comment:
-
I did confirm the encoder pins connect to pins 41 and 42 on the chip and then I found this:
I haven't been able to get the encoder...Leave a comment:
-
I added the binding posts and switch to the back so that I could choose to use the stock drivers or bi-amp another speaker with drivers suited to the...Leave a comment:
-
1. ~0.1 ft^3
2. 1" diameter x 5.5" long with flares
3. Tweeter Re is 5.5 ohms and woofer Re is 3.1 ohms....Leave a comment:
-
Tweeter disconnected...Please note that these measurements were with the baffle removed (open baffle).
...Last edited by silverD; 01-02-2020, 01:14 PM.Leave a comment:
-
Woofer disconnected...Please note that these measurements were with the baffle removed (open baffle).
...Last edited by silverD; 01-02-2020, 01:15 PM.Leave a comment:
-
Some measurements of the Ikea Sonos with the new toy.
...Leave a comment:
-
Tweeter Re is 5.5 ohms and woofer Re is 3.1 ohms.Leave a comment:
No activity results to display
Leave a comment: