...
Kornbread
Senior Member
Last Activity: Yesterday, 08:46 PM
Joined: 10-24-2015
Location:
-
Do the new ones have much fan noise, the old eps' do?...Leave a comment:
-
Did they discontinue the iNuke series? All I see on PE's site are the old EP series and a newer NX series....Leave a comment:
-
The outer dimension of the Rival woofers from RAD are 7". Not a lot of them out in the diy world yet but word has it they're pretty darn good....Leave a comment:
-
If you are using the rs225, be aware its outside dimension is about 9". That doesn't leave much if your max width is 10"....Leave a comment:
-
I'm thinking something like the aura ns3, aka PicoNeo. Pretty much no crossover, plays way louder and lower than it should, and a proven performer. ...Leave a comment:
-
So you want to build it ay ...
I'm thinking an mtm configuration using 4 dayton rs180-8 woofers and 2 dayton rst28f or a tweeters. That should...Leave a comment:
-
I'm thinking anything with 2 8" woofers, 2 5" mids, and a tweet are going to be rather large. How much room do you have to work with? I'm getting...Leave a comment:
-
Sealed would be a little easier to build and design, might withstand a bit more power than ported. I wondered what a kl650 was so I googled it and my...Leave a comment:
-
I eventually hung carboard panels from the ceiling with string before abandoning the experiment. It started with blue insulation board (xps) mounted...Leave a comment:
-
Haven't found a good selection of nylon bolts locally, so I decided to do a little experiment. I have some non-magnetic stainless steel bolts and wondered...Leave a comment:
-
Why not just use an in wall volume control? https://www.parts-express.com/cat/in...-controls/1956Leave a comment:
-
It's going to be a long long shot for me, but I have plans for the 10th....Leave a comment:
-
Ya know, if you need something small that can dig pretty deep. This is is a TangBand 6½" sub in 1ft³ ported. Might want to double check my work...
Leave a comment:
-
Jim Dawes Have to give credit to Roemer as it was his work, I just laid it out in XSim so you might better understand how the components went togeth...Leave a comment:
-
Is that Lexan or Plexiglass and how thick is it? Do you chuck that into a drill?...Leave a comment:
-
I struggle even with Sketchup but was able to get a good idea of what the finished product was going to look like along with all the volumes and dimensions....
Leave a comment:
-
I just prefer the look of the open coil held by ties vs the plastic spool and I'm trying to see just how much stuff I can recycle. But yea, the plastic...Leave a comment:
-
Didn't think of that.
Managed to wind a couple small coils, a .87 and .7mh from the ~22 gauge wire. Ohm's were higher than I'd like at 1.5...Leave a comment:
-
Just so happens there is an old 55" Mits sitting around ... the wire on the tubes was really small, smaller than the ~22 gauge I pulled from the...Leave a comment:
No activity results to display
Leave a comment: