I am building my son in college a subwoofer using the Infinity 1260W driver.
I asked previously about DIY amps and crossovers and decided to buy...
a4eaudio
Senior Member
Last Activity: Yesterday, 11:43 PM
Joined: 06-07-2017
Location:
-
Sure amp and Mean Well power supply, anything wrong with this?
-
Keep in mind this digression on group delay was NOT the original poster's question, but came up in one of the responses. Drjay is adding questions and... -
I have the Speaker Building 201 and I like it, but unless you are going to start this as a hobby you can find all of the information you need on the internet,...Leave a comment:
-
If you are designing a speaker for general use, i.e., not knowing what the room might be like because it may move from room to room or be given away,...Leave a comment:
-
Going back to the original question... Bill, fpitas and Chris pointed out that the preloaded/named alignments are a relic of the past before software....
Leave a comment:
-
Because playing in WinISD is more fun than my day job, I couldn't resist.
I ran all 5 pre-loaded alignments as well as a custom alignment...Leave a comment:
-
Well, I wasn't trying to "call him out". I am completing a pair of Hitmakers which I knew are wider than that and wondered if they were unusually...Leave a comment:
-
Quick search of popular kits (baffle width):
Overnight Sensation: 6.0"
S2000: 6.0"
C-note: 7.5"
Tri-trix:...Leave a comment:
-
Teaching you to fish...go to this site https://midwestaudio.club/resources/...ners-tutorial/ about a quarter of the way down and it tells you the order...
Last edited by a4eaudio; 06-22-2020, 06:24 PM. Reason: EDIT: The link is a good tutorial, but Bill already gave you the list of parameters "needed".Leave a comment:
-
I think you should reconsider Chris Roemer's suggestion. The cost isn't relevant if 2 TCP115's cost about the same as 1 high-sensitivity driver. Some...Leave a comment:
-
Pretty cool tip Wolf. I'm trying it and will post how it turns out....Leave a comment:
-
I did do some research and got the wet sanding technique that you described correct. But that may be the only thing I got correct. I think I over sanded...Leave a comment:
-
How do you sand the last coat of gloss paint before the clear coat?
What do you use for "clear coat"? I thought that was a general term...Leave a comment:
-
Piano Gloss attempt - what went wrong?
Trying to make piano gloss black speakers.
5 coats of flat black paint (rattle can), sanded with 400 grit between coats. My last coat of black paint... -
Sambas, Helix, Speedsters, Hitmakers, Overnight Sensations, C-Notes all have an F3 between 40 and 45Hz.
I think most DIY ported bookshelf speakers...Leave a comment:
-
The Ares was a Pete Schumacher design using the 5" Anarchy compared to the Apollo's that used the 7". But the Ares aren't listed anymore....Leave a comment:
No activity results to display
Leave a comment: