"Newer modern Foam surrounds have special coating that prevent the disintegrations - no first hand experience though. "
I remember...
-
I have a very old Rockwell contractors table saw with a very nice aftermarket fence, which I lucked into on Craigslist. But I've been seeing a lot of...Leave a comment:
-
^^^^ what he said!Leave a comment:
-
You might want to play around with my crossover simulator program (free, Windows) XSim, you can easily play with topologies and see and get a feel for...Last edited by bwaslo; 07-15-2017, 04:03 PM. Reason: man, I wish this forum software didn't strip off most of posted links! I added the actual link in plaintextLeave a comment:
-
If I were you, I'd take a trip to see that Crafsman saw you linked. If the fence is still good, that looks pretty nice for speaker cab work. The belt...Leave a comment:
-
"- Good fence (what makes a "good fence?") How can I tell something is good by looking at it?"
Does it stay perpendicular...Leave a comment:
-
In related news, Photobucket soon to go out of relevant existence...Leave a comment:
-
I got a (very) old 36" bed Rockwell model 10 belt drive saw that had an aftermarket aircraft-wire aligning fence on it, from Craigslist. Guy even...Leave a comment:
-
TN Allen, you might want to look at my pdf doc at the links below for more Synergy horn propaganda.
There is also an xls doc at
http://li...Leave a comment:
-
There are a number of advantages to Synergy (or Unity) type horn speakers ==
* constant directivity over a wide range. Imaging is very...Leave a comment:
-
The GRS looks pretty nice. Looks like you could mount it to a horn wall without a big spacer or worrying about the cone crashing, too. Is it's sensitivity...Leave a comment:
-
Yeah, HR does model that. You can see on some models the low end tick up when the back chamber size is reduced (assuming the horn and driver are right...Leave a comment:
-
So you're not planning on using reactance annulling (stiff compliance behind the cone to offset mass of air in the horn) to pull up the low end?
...Leave a comment:
-
John, interesting project, hope it comes out well. I'm surprised you're able to easily get a small enough volume chamber behind the mids to work with...Leave a comment:
-
Thanks for the encouragement guys. The mids are the celestion 4" sealed-back mids (can't remember the model number at the moment).
...Leave a comment:
-
Timely that i just ran into this thread. I've been playing with 3D printed waveguides, particularly "Synergy Horn" types. I've printed these,...Leave a comment:
No activity results to display
Show More
bwaslo
Midrange Member
Joined: 01-12-2008
Location: Portland, Oregon
Leave a comment: