devnull
Been Around Awhile
Last Activity: Today, 10:18 PM
Joined: 05-30-2018
Location:
-
You learn something new every day. I was thinking about the subs being crossed over high enough that the low frequency sound would still be directional/locatable,... -
Do a simple test use the 7,1 analog inputs and see if there is a mode that outputs the LFE channel through the speakers. Only hook up the LFE channel...Leave a comment:
-
Half sections are easier to work with in terms of cutting and mounting than 1/4 sections at least when testing. If you don't want cut them freehand then...Leave a comment:
-
If you want to play with different sized round overs why not build a plain test box and then use some PVC pipe split lengthwise to make different sized...Leave a comment:
-
Here's the stuff that Olson did from back in the 50s. The bigger the radius the better. I couldn't find in the mess on my computer, but you might want...Leave a comment:
-
What about a 90 degree bracket, maybe a shelf bracket, on the back and then a hose clamp around the bracket and speaker magnet assembly. Or just put the...Leave a comment:
-
Good point, guess I should have been a little more articulate. I was thinking about cheap speakers that just use a single cap in line with the tweeter...Leave a comment:
-
Series crossovers can be used to help increase the overall impedance of a speaker, instead of two 4 ohm speakers in parallel they are now in series. ...Leave a comment:
-
You might think about doing the subwoofer crawl with a couple of standalone subwoofers. It would really suck to have gone through all the work and find...Leave a comment:
-
A wall wart would work fine. Have you tried disconnecting everything from RCVR? The reason I ask is because I've seen ground loops/hum caused by a coax...Leave a comment:
-
Trying running a wire from the GND on the receiver, under HDMI 1, to a GND on the AMP touching it to the outer conductor of one of the RCA inputs. Try...Leave a comment:
-
I think people are questioning the overall picture you're trying to paint. Here's my take on this thread, the coax thread and a couple other threads...Leave a comment:
-
Sounds like a ground loop and either the receiver or amps have a two wire power cord. Try hooking up a wire between the chassis ground connection on...Leave a comment:
-
And don't forget about the fact that the M2 needs a Crown 5000HD amp with DSP per speaker, so add another 12K or so to total cost, No crossovers so it...Leave a comment:
-
Actually depending on how narrow or wide the sqigglie is determines at what level it becomes audible. Toole in his paper "MAXIMIZING LOUDSPEAKER...Leave a comment:
-
Those look just like the coaxials that EV used to sell that had the T35 horn tweeter mounted on a center post....Leave a comment:
-
Try taking it at the volume control. It's a pretty close design to a TI or Sure reference board. The Sure reference boards show the volume control out...Leave a comment:
-
You could use something like a memory backup cap across the input. For longer backup on 5V stuff, think the router up in my attic, I use a USB portable...Leave a comment:
No activity results to display
Leave a comment: