LOUT
-
I wonder why this forum doesn't have something like a 5post minimum before new users are allowed to post links? I think many forums use that to limit... -
Maybe a dumb question, but are you planning on playing them pretty loud (near-ish full power) and you're okay with them sounding noticeably thin?
...Leave a comment:
-
Silver lining, some of these spam necro's reopen some pretty interesting threads that I otherwise wouldn't have noticed. This one, however, leans more...Leave a comment:
-
It looks like the tweeter might benefit from a 1ohm resistor between the capacitor and amp, both to tame the 5-8khz response down a little bit and push...Leave a comment:
-
I've heard it shouldn't make a difference for port tuning or bass response or anything like that.
I think it should work like many store-bought...Leave a comment:
-
The 34hz rating means the manufacturer believes those speakers won't lose too much efficiency/volume at those low frequencies...the speaker should be...Leave a comment:
-
I might be doing it wrong or maybe I'm just not using it with the right tweeters, but so far it looks like a zobel on a tweeter only drops the >20K...Leave a comment:
-
I thought a standard Zobel-filter was used to flatten the impedance without affecting the frequency response. What does a Zobel on a tweeter do to the...Leave a comment:
-
Maybe a dumb question, but are you asking about the inductor bump down near woofer FS that sometimes happens with large-value/low-R inductors, or are...Leave a comment:
-
I think the SD215 acts a lot like the DS/DA/DSA215 woofers with extended XMAX and some added weight (probably from the extended XMAX coil depth and the...Leave a comment:
-
Unless I'm looking at the wrong plate-amp, those claim 30right+30left+60sub watts at 4ohm (doesn't appear to specify a separate ohm-rating for the sub...Last edited by LOUT; 11-13-2020, 01:03 PM.Leave a comment:
-
If someone isn't well-attuned to recognizing slight-to-modest tweeter distortions, are there particular things to pay attention to and sounds/audiotests/noises...Leave a comment:
-
Sorry if you already mentioned it and I missed it, but do you already have the other speakers (the 2way woofer+tweeter) picked out?
Likewise, what'll...Leave a comment:
-
Internet sites usually shouldn't need app versions of the same thing.
If the mobile browser experience is bad, just make some helpful tweaks to...Leave a comment:
-
If the radio has enough volume/headroom that it can currently crank up an easily noticeable bit louder than you need, you might try a passive parallel...Leave a comment:
-
I'm pretty sure the voice-coil heat that a speaker can handle is expressed as its wattage-handling spec...so a speaker by a reputable brand that claims...Leave a comment:
-
Can you measure how much internal space the speaker cavity/box-section has, and also share if it's sealed or left to leak air into the rest of the box...Leave a comment:
-
I've read that they fall far short of their claimed watt/power-output...if true, that kind of puts a big dent in the power4money benefit they should offer....Leave a comment:
-
Does the flexible stuff you're currently using seem to loosen up after a while of use/movement...like a kind of break-in period for PR?Leave a comment:
-
I think using three of those 2inch flared ports (near their maximum length) should work pretty well and let you reach an F3 around 25hz in a 3ft-cu box....Leave a comment:
No activity results to display
Leave a comment: