Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I would try to attend if the Covid situation permits. Realistically, this probably means the later the better....
Leave a comment:
-
Thank you. I'm going to think a while on how to style the finished design. I think they deserve something not 100% traditional.
Leave a comment:
-
-
So, I put it together, with a bit of length adjustment and impedance measurements, I have it tuned to 46Hz with a final length of 53cm. Running without...
Leave a comment:
-
I recall seeing something in the past about placing lossy patches in the wall of a port, at the nodal points for port resonances, (I think it may have...
Leave a comment:
-
I made it in the form of a doghouse which can sit on the back of an existing test box I have. If I have time, I'll give it a shot this evening....
Leave a comment:
-
I hope with the crossover at ~200Hz the port resonance won't be a problem. Do you think there could still be a problem?...
Leave a comment:
-
Haha, I just need a marketable name for it, how about an Acoustic Mass-Wave Resonator!
Leave a comment:
-
Interesting.
For what it's worth, this is a 1.8l box with 50cm of port on the back....
Leave a comment:
-
Thanks for the tip, they come out in WinISD just as you described. Whenever I try to model with that Peerless PR I seem to get strange results....
Leave a comment:
-
I'm far from an expert here, but isn't 50g added mass going to really mess with the transients? I'm not looking at more than 1 W3 per speaker. I figure...
Leave a comment:
-
3rutu5. I'm not sure if you are set up for multi material, but if you are, I had some (limited) success in the past printing flexible button membranes...
Leave a comment:
-
See my comment above about poor success modeling the enclosure with a PR. (Probably my own failing :-D) The port sounds intimidating to start with, but...
Leave a comment:
-
I'd be very interested, especially if you managed to model the behavior well with the passive radiators. I tried putting that radiator into WinISD and...
Leave a comment:
-
Interesting. Since I have the drivers, I cannot think of a good reason not to try this.
Sounds like a good candidate for bi-amping...
Leave a comment:
-
How about this near field micro-monitor idea?
I was thinking about what might make an interesting project, something which could reach pretty low in a small box, and I came up with this:
...
-
Yeah, that's just an adapter to fit it in a test baffle originally made for an RS100...
Leave a comment:
-
Ok, rear mount fail. I made a nice invertible mounting ring so I can mount an ND65 either way around in the test chamber and do an A/B comparison. I managed...
Leave a comment:
-
Driver spec sheets should be directly clickable on the driver page. Having to click on the "manuals & resources" tab each time is a bit...
Leave a comment:
No activity results to display
Show More
Leave a comment: