PWR RYD
Seasoned Veteran
Joined: 12-01-2009
Location: Rockford, IL
-
Sorry to pm you the other day. Guess I got a little anxious wanting to get something made before summer projects. My bad. I was very busy with speaker... -
Your crossovers look fantastic! Nice work dynamo. -
Yours looks better? How so? More colorful zip ties? Unused zip ties?...Leave a comment:
-
Yes same mics and Holm, Arta, Soundeasy, or OmniMic....Leave a comment:
-
In this case for HD you would need to either rely on a third party measurement (like Zaphaudio) or measure it yourself. The manufacturer graph provided...Leave a comment:
-
A few tweeters follow that ROT but a lot don't. The XT25TG needs to be crossed much higher. The harmonic distortion performance of the tweeter determines...Leave a comment:
-
The published frequency response looks like it would be a challenging tweeter to work with. You may end up with as much cost in crossover components...Leave a comment:
-
I totally agree. It likely may have no audible impact for you. But like Wolf said, it's not "per design" so proceed knowing that....Leave a comment:
-
And sometimes, like in my case, you have a pair of RS28A tweeters that are no longer available. The different padding resistor value was simple and fixed...Leave a comment:
-
Yes, I have had to pad tweeters with different value resistors to get a good balance. Otherwise the sound stage was pulled to one side.Leave a comment:
-
Did you measure them with the voice coils connected in parallel? Your Qts is double the manufacturer's spec.Leave a comment:
-
+1000
I had my basement flooded with sewer backup twice! It was determined that the cause was people in the new subdivision up hill from...Leave a comment:
-
Does the designer have any technical data available for this project? I would think someone interested in building this design would like to see, at...Leave a comment:
-
Make sure you only have one speaker hooked up and playing when you take your measurements.Leave a comment:
-
...
Leave a comment:
No activity results to display
Leave a comment: