Almost forgot. AJ, I think I got it figured out.

[shawn_a]

I did a bit of knocking about on the PCD in the small hours of this morning. I think I've got the 2.5 way TMM with the DA135's to a point where I can say I like it. I ended up trying out the Audax TM025F1 and the Morel MDT-20. When it's all said and done I think I prefer the Audax so far based on the modeling. I think I'm going to pick up some DA135's and a pair of the Audax tomorrow if I can get out of town for a few hours. I already have the Morels in house and I will build a test enclosure so I can swap out the two very different sized tweeters easily. The proof is in the listening after all.

I still need to tweak out a few values before I release it but it's looking good. Just wanted to let you know I haven't given up on this project.

shawn

[AJ]

Hey, thats cool. I figured you'd get it worked out.

I don't know when i'll get around to building them though as i think my next project is going to be desk speakers. I'm mainly considering the rs125/K1 MT that Hong posted an x-over for below. I don't know how much longer i can go without sound in my bedroom/office.

When i do build them though, i'm thinking towers! Something like .75ft^3 tuned to 45hz. Probably 38" tall (gonna need a spacer in there) 7.5" wide and 10" deep. With the x-over in the bottom section and a back door to get to it. Should be nice looking. Or i may build them sooner instead of the MT and put them too the left and right of my desk.

Ok, i'll stop thinking aloud.

AJ