Morel Speakers

[teyoung1]

I have a couple of Morel MW142 Woofers and a pair of MDT33 Tweeters. I need some help on Crossover design and box size. Any help would be graetly appreciated!

[unknownuser]

Provided Link: Devon MK2 Kit


Hello Todd the devon MK2 Kit uses the drivers you mentioned with a MW166 as a bandpass sub woofer. Follw the link below and you will find the crossover etc...


(Originally posted by: Heffo)

[unknownuser]

Provided Link: Devon MK2 PDF


Found a better link for you this is a PDF file in English


(Originally posted by: Heffo)

[Chris Roemer]

> I have a couple of Morel MW142 Woofers and a
> pair of MDT33 Tweeters. I need some help on
> Crossover design and box size. Any help
> would be graetly appreciated!

2nd order HP w/L-pad:
series pp cap 7.5uF
#20 0.80mH shunt coil
SR = 5 ohm, PR = 5 ohm

2nd order LP w/Zobel:
#18 1.4mH series coil
15uF npe shunt cap
Zobel = 12 ohm resistor + 6uF npe cap

SPL = 84dB +/- (really burnin' off tweeters)

A 0.35 cf box w/ 2"dia. x 10" vent should yield mid 40s.

[Wolf]

Provided Link: Bob Cordell "M3"...


It gives some explanation of the box assembly and alignment, and the transient-accurate first order xover on the drivers used. FWIW, these have been one of my top-ten favorite speakers listened to for quite some time. Just very clean...
Later,
Wolf