lookng for center channel plans

[bswisher]

I am finishing up Pete Schumacher's DA175/HIVI K1 speakers. I am looking for center channel speaker plans that will go well with the speakers I just built (which were 2 midrange DA175, 2 woofer DA175 and 1 HIVI K1 per speaker).

Thank you.

B

[Pete Schumacher ®]

Provided Link: UniCC


> I am finishing up Pete Schumacher's
> DA175/HIVI K1 speakers. I am looking for
> center channel speaker plans that will go
> well with the speakers I just built (which
> were 2 midrange DA175, 2 woofer DA175 and 1
> HIVI K1 per speaker).

> Thank you.

> B

That's what Scott S did a while back.

You could just build one more of what you already have, big as it is. But if you want to cut down one the size, a pair of those woofers and the same tweeter would match well. Just put the tweeter above a pair of those woofers sitting side-by-side.

But this would make for a great center channel.

Check the link below.
<A HREF="http://www.partsexpress.com/projects...?project=UniCC">http://www.partsexpress.com/projects...?project=UniCC</A>

[bswisher]

If I do two woofers and a tweeter, am I wiring one woofer for mid and one for low?

B

[Pete Schumacher ®]

> If I do two woofers and a tweeter, am I
> wiring one woofer for mid and one for low?

> B

Just a two-way, not a 2.5-way. The XO is a little simpler too.

[bswisher]

So basically I am getting rid of everything after where the mids hook up - deleting the Iron core coil, 6.8uf cap and 22 resistor?

B

> Just a two-way, not a 2.5-way. The XO is a
> little simpler too.

[Pete Schumacher ®]

> So basically I am getting rid of everything
> after where the mids hook up - deleting the
> Iron core coil, 6.8uf cap and 22 resistor?

> B

The XO will need to be reworked.

Shoot me an email to remind me to re-run the sim.