Holm to pcd

[killa]

What is the best/easiest method to get holm files to pcd? I know they can be traced. I assume I need phase and frequency from holm and I use wt3 for impedence?

[rpb]

What is the best/easiest method to get holm files to pcd? I know they can be traced. I assume I need phase and frequency from holm and I use wt3 for impedence?

Ryanbouma posted how to do that. If you search, it should come up.

What are you building? Two way? Three way? You could come over to the dark side and use trial and error.

Found it here. Post #75 http://techtalk.parts-express.com/sh...=227957&page=4

[killa]

Ryanbouma posted how to do that. If you search, it should come up.

What are you building? Two way? Three way? You could come over to the dark side and use trial and error.

Found it here. Post #75 http://techtalk.parts-express.com/sh...=227957&page=4

3 way. I know a 3way might be a little much for a first design but I like a challenge and I have been learning for quite a while. I take it you mean add components by guesstimation and remeasuring? I think I'll use pcd to get close and play around from there.