I bought the ERSE 1.5mH 18AWG inductor and noticed some of the wires were lose. I know inductors are wound around a certain diameter a certain number of times. I tried to zip tie it back, but it doesn't lay next to the other wires.

My question is will this make a difference? I'm building three speakers with the same inductor and this is the only one that is like this. I bought the other two inductors a year ago and they came from the factory with two zip ties, instead of one, like this picture.



Here is the wire lifting up, you can tell it's shorter than the other wires, so it won't lay next to them.



This is in no way to flame PE, they have the best customer service out of any company I've ever dealt with. I'm just trying to figure out to send it back or not. I took this week off work to build these speakers. I did build the crossovers so they can fit through the woofer hole so if I do have to wait for the inductor I can finish the speakers and install the crossover last.