Omni calibration file format

[exojam]

I was wondering if someone could tell me the format of the Omni calibration file.

Below are a few lines from mine. It appears the first column contains the frequency, the second the is value needed to correct that frequency(?) and I am not sure what the third number is.

4.6758 -0.2119 6.12
5.099 -0.1226 6.27

Thanks.
James

[greywarden]

I believe they are freq, amplitude, phase

not 100% on that, though, but that's usually the order of the three.

[Jeff B.]

I believe they are freq, amplitude, phase

not 100% on that, though, but that's usually the order of the three.

Yes, it is essentially an frd file with the same three columns.

[exojam]

Thanks guys for the time and reply.

So basically the second column is the correction value in db for the first column? Just asking to make sure I am following it.

James

[Jeff B.]

Thanks guys for the time and reply.

So basically the second column is the correction value in db for the first column? Just asking to make sure I am following it.

James

Yep.

[exojam]

Thanks Jeff.

Now if I could only get the cal file into a filter for Spectrum Labs I would be golden.

James