new box-what to do?

[manu et deo]

in my other thread i was trying to use a old cabinet as a sub box. now after some discussion with the missus, she wants to take another look at using our existing end tables for the box.
internals are 21.75W*21L*16H=4.61ft3 i think and are 1.25-1.5 solid maple top, bottom and sides

would be side firing with port on same side

da 250 plate amp for power

front and rear baffles are not in that dimension

plate amp fin must also fit inside space if possible so i can keep doors

300$ total for driver, amp and port less is best

if it works may turn other table in to sub down the road

thanks for all the help

[manu et deo]

what do you guys think about the 310-88 or the 315-88 looks like they might work

[manu et deo]

also i noticed these drivers like a 3.5 ft3 enclosure, so i could shrink the insides to make this work

[Chris Roemer]

Your OTHER driver selection (385-88) should be capable of mid 20's in that box (I calc it as 4.2 cf, but - either way . . .) using a pair of 4"id vents, about 26" long.

[manu et deo]

i just measured the rough internals and didn't take into account the baffles or bracing

what about the 380-88?

those ports would have bends then, maybe a slot instead?

Your OTHER driver selection (385-88) should be capable of mid 20's in that box (I calc it as 4.2 cf, but - either way . . .) using a pair of 4"id vents, about 26" long.