Sent in an OmniMic for repairs....will the new one have a calibration file?

[hardwareguy]

The thread title is pretty much the question.

I sent in my OmniMic for service (it refused to make USB connections) and I forgot to inquire about the calibration service when I spoke to customer service.

It was RA#: 36234 if that helps.

[arlis_1957@yahoo.com]

if its the new version, it should be available on the dayton audio sight. if its the old one, then use the same number you used when you bought it.

[hardwareguy]

You guys ROCK! I got the revised V2 unit....and the problem I had should never happen again thanks to the full size USB port.

Wall Street could take lessons from PE on how to run a business. Thanks guys!

Now on to grab FS graphs for an Avid 102 woofer....10" 2 ways, always a challenge.