WT3/DATS problem.

[tombond]

No matter what I hook up I keep getting: "A sufficiently well defined resonance was not found". It was working a few weeks ago, I've never seen this before.
Start up was normal, calibration was fine. I've restarted the program several times, waited for stabilization. Any ideas?

[tombond]

Ok, never mind. I decided to set up the USB port again and that solved the problem. Evidently this computer won't save the settings for that port. Damn annoying to have to set that up every time.

[arlis_1957@yahoo.com]

I have got this before as well. Plugged into another Han port checked the settings and it did fine. They very moody sometimes.

[DrBoar]

Make sure that you have the sound volume high enough (full blast) if the output is to low all you get back in noise and then there will resonance to be found.