Sent in an OmniMic for repairs....will the new one have a calibration file?

[hardwareguy]

The thread title is pretty much the question.

I sent in my OmniMic for service (it refused to make USB connections) and I forgot to inquire about the calibration service when I spoke to customer service.

It was RA#: 36234 if that helps.

[[email protected]]

Re: Sent in an OmniMic for repairs....will the new one have a calibration file?

if its the new version, it should be available on the dayton audio sight. if its the old one, then use the same number you used when you bought it.

[hardwareguy]

Re: Sent in an OmniMic for repairs....will the new one have a calibration file?

You guys ROCK! I got the revised V2 unit....and the problem I had should never happen again thanks to the full size USB port.

Wall Street could take lessons from PE on how to run a business. Thanks guys!

Now on to grab FS graphs for an Avid 102 woofer....10" 2 ways, always a challenge.