Vigor - a laser cut knockoff of a cardioid design

[silverD]

The ones that I built at the beginning of the thread were more or less to spec based on the other brio threads out there. If I remember correctly the tuning is only about 120 hz in the speakers definitely need a subwoofer.

[3rutu5]

Just curious on the volume and what frequency these are tuned for? I'm on the hunt for a smaller build, but think they may be similar in height and width to my current PC speakers, just half the depth.

[silverD]

Hi 3rutu5,
I'm happy to provide info on the Vigors. Let me know how I can help.
Nate

[djg]

I pm'd you.

[3rutu5]

these look unreal silverD , guessing if you are selling these badboys there probably isnt build information out there

[silverD]

Yep, 3/8" #6 screws. The back panels are removable to allow for the installation of the driver and cap. I glued in cleats to allow the rear panels to be sealed and screwed in.

[djg]

Nice. You had to use super short screws to rear mount those drivers and not poke through the front.

The rear panel is removable?

[Jake]

Really like the trim rings.

[ceiol]

looking good!!! I like the newer design with just the mounting baffle for the top speakers

[silverD]

I just finished up a Vigor Trio set made from walnut and a repurposed Mirage Nano Sub with a TB W6. They will be a gift for some family members.

[ceiol]

All done

[silverD]

They look great too. Nice thread you have up.

[djg]

My set.

[ceiol]

Can’t remember where i got those binding posts. Found them in my speaker project supply cabinet. The trim rings make the TC9 look much nicer.

These speakers sound great! Off axis I miss having a tweeter but on axis, it’s great.

I need to order another flat pack set from you!

[silverD]

They look great ceiol! I see you printed the TC9 trim rings. What binding posts are those? The full Trio, nice. That woofer needs less than a cubic foot ported to dig deep.