Announcement
Collapse
No announcement yet.
Paul Carmody's Swope MTM build from India
Collapse
X
-
They look great - especially for a first build! Well done. Now you can sit back and enjoy the music!
-
Hello Everyone,
I had caught up with some personal work, couldn't find time to finish the speakers. Finally last weekend I took some time to finish the speakers. The material I chose is Virgo 0.8mm wood grain pattern. I tried to match the grains pattern from side to side, it came out pretty good. I have learned many things from my mistakes in this project and you could see that in the details. I am very happy and satisfied with how it came out after finishing.
Thank you all members of this forum for helping me in some way to finish this project. Special thanks to Chris Roemer for helping me with all queries.
Leave a comment:
-
I would definitely recommend a laminate finish - it is a LOT of work to get a satisfactory paint finish over MDF. I've seen professionals apply laminate to MDF first and THEN apply the paint finish to get a better result.
Leave a comment:
-
Weekends are awesome Finally, I got some time to put together everything and had a good listening session too. Initially, when I listened to it, I felt like something is missing in HF. Then I checked the wiring and found one of the tweeter polarities has been reversed. Oh, Thank God you helped me figure it out soon. It sounds good looking forward to inviting my friends to listen to it post COVID. Thanks again Paul for such a nice design.
I am planning to finish it either with paint or laminate sheet, any ideas, please comment.
Leave a comment:
-
Sorry, I misspoke.
BOTH your XO pics look correct. I (mentally) swapped the 22uF NPE w/the 6.8uF pp cap (which has a smaller value, but is larger in size - since it's NOT an npe).
Leave a comment:
-
Originally posted by Chris Roemer View PostI THINK your 1.5ohm (tweeter) series resistor needs to go to the other end of the coil (so the cap, coil, & resistor make a "T" - like in Paul's schemo).
If I'm seeing your layout correctly ... ?
Or I misunderstood, you may be talking about the placement of the parts in layout, does it matter really?
Leave a comment:
-
I THINK your 1.5ohm (tweeter) series resistor needs to go to the other end of the coil (so the cap, coil, & resistor make a "T" - like in Paul's schemo).
If I'm seeing your layout correctly ... ?
Leave a comment:
-
-
Looking good! Nothing some filler won’t solve. Mistakes are just part of the process
Leave a comment:
-
Whoops!
Oh well...at least you remembered to mirror the tweeter offsets. I finished up routing out speaker cutouts in a project once with offset tweeters and looking at them side by side after I realised I marked the both out on the same side.... Had to cut a plug, glue and fill and try again!!
- Likes 1
Leave a comment:
-
Today I had some time to route the holes. I have made some mistakes too like forgot to lock the depth couple of times, Will fix it with wood filler or putty.
Leave a comment:
-
Update: I got some time this week, so I have put together the other enclosure too except the baffle, even I trimmed the edges using the router. it looks like only a minor sanding necessary later.
I have decided to use a double-layer baffle, done the cutout too.
Just the speaker holes to be routed, experts tips to do so are most welcome. The dry fit looks perfect
There is so much sawdust in my house, So I need to complete this soon before being kicked out of the house.
Using a router without proper workplace and gears was a bad idea, should have taken it to a carpenter.
There is heavy continuous rain in our place(Kanyakumari) so there is often power failure, which again slows down my progress. Hope it will be better tomorrow.
So far so good thank you for looking.
Regards
Jean
Leave a comment:
-
Leave a comment: