E-Wave SR Compacts

[Big Stogie]

I built the PE trap cabinets and they are ok but need much more finish work than I expected. If I had it to do over I likely would have just built some from scratch. I rear ported them and am moving the baffle up to the front. I will take some pics and get them up soon.
Mike

[[email protected]]

Re: E-Wave SR Compacts

dont tease us.

[Big Stogie]

Re: E-Wave SR Compacts

Box progress, rear ports, I made new baffels buy using 2 layers of 1/2" ply. I intalled the hardwood mount supplied with the kit and am going to cut the center out of the factory PE baffels to space them forward. This gives me about 1/8" from the front edge wich I will remove with the router. Hopefully that will get done today and the new baffels cut out for the drivers.
Mike

[mattp]

Re: E-Wave SR Compacts

Box progress, rear ports, I made new baffels buy using 2 layers of 1/2" ply. I intalled the hardwood mount supplied with the kit and am going to cut the center out of the factory PE baffels to space them forward. This gives me about 1/8" from the front edge wich I will remove with the router. Hopefully that will get done today and the new baffels cut out for the drivers.
Mike

Lookin good! What are these going to be use for?


That F-350 sittin in the parking lot is awefully sexy too...:D

[Big Stogie]

Re: E-Wave SR Compacts

these will be for some HT and music in our play room. The kids like to dance and they like it to get loud. I am building two BMF table tubas to go with them loaded with some HL10C's and running those with a second XLS602. I have some of the XD120's from the E-Wave thread and if I ever get these done I will build the surrounds and center from those. The F350 is our work truck that we also use to pull our snowmobile/car trailer. Thanks
Mike

[Big Stogie]

Re: E-Wave SR Compacts

Baffle spacers done, baffles done, need to mount those and flush trim the box to the baffles + round over the sides. then begin the finishing process. Battey dead on camera pictures hopefully tomorrow.
Mike