Where to buy small black screws...

[djg]

Thought this might be helpful to some, left to right, #4, #3, #2, #1, #0, #00 Phillips drivers. 3,2 and 1 are the most common. Phillips size does not correspond to screw size.

[tomzarbo]

i've found these to be handy at times. http://www.rockler.com/drawer-slide-...-head-phillips

I use ones just like those. The ones I use are called Lathe screws and look the same... big head and about 1/2" long. Great for where you need a large flat hold-down head.

Thought this might be helpful to some, left to right, #4, #3, #2, #1, #0, #00 Phillips drivers. 3,2 and 1 are the most common. Phillips size does not correspond to screw size.

Nice. Thanks for the photo. I've found that with screws some have good engagement and others (usually cheap ones) don't. The ones I purchased were real nice in that regard.

TomZ

[Whitneyville1]

Tom, you're original question reminded me of an old sexist, racist joke. You're responsible for a nosefull of Diet Dr. Pepper on my keyboard.....

[tomzarbo]

Rut-Roh! Sorry bout that. You better clean it off soon... Dr. Pepper will gum that keyboard up really bad.

TomZ