Announcement

Collapse
No announcement yet.

Help with crossover for the Armadillo Center Channel

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Fractals
    replied
    according to bolland83 and Mark65 (the designers), "Yes, indeed, mid is reverse polarity."

    Leave a comment:


  • Fractals
    replied
    Would this be correct?
    Attached Files
    Last edited by Fractals; 01-08-2020, 05:16 PM.

    Leave a comment:


  • Fractals
    replied
    Okay, that sounds better. Thank you Chris.

    Leave a comment:


  • Chris Roemer
    replied
    That all looks pretty feasible, except I don't get your woofer wiring.
    From the RCL juncture, run a wire to the 1st woofs "+" term, then run a single wire from W1's neg term to W2's pos term, lastly from W2's neg term back to your com grnd.

    These woofs are in series; I think you've drawn them in parallel (and out of phase w/ea. other).

    Leave a comment:


  • Fractals
    replied
    (-) input from the receiver is ground, yes? I used green for the wire color.
    (+) input from the receiver i used red for the wire color.

    a wire from GROUND goes to each (-) terminal of the speakers?
    a wire to the positive terminal comes off of each part where the speaker label is?

    Here is the original images and thread:
    http://techtalk.parts-express.com/fo...center-channel

    Click image for larger version

Name:	image_40158.jpg
Views:	195
Size:	127.5 KB
ID:	1428631 Click image for larger version

Name:	image_40155.jpg
Views:	193
Size:	119.7 KB
ID:	1428632 Click image for larger version

Name:	image_30225.jpg
Views:	159
Size:	125.0 KB
ID:	1428633

    Leave a comment:


  • rpb
    replied
    The woofer wiring shown is wrong. I can't follow the rest.

    Leave a comment:


  • Fractals
    replied
    here's the crossover: Click image for larger version

Name:	image_28607.jpg
Views:	176
Size:	40.0 KB
ID:	1428611

    Leave a comment:


  • Help with crossover for the Armadillo Center Channel

    Hello All,
    I just purchased the parts for the armadillo center channel that I'll be upgrading to (from Paul C's overnight sensation center channel). However, I'm a bit confused as to how exactly to run the wires from the receiver / inputs to the speakers. I'm including my horrendous sketch / mockup and could use some yay or nay on how it should go.

    Any advice would be greatly appreciated.


    Click image for larger version  Name:	image_82500.png Views:	4 Size:	700.6 KB ID:	1428590 Click image for larger version  Name:	image_82501.jpg Views:	4 Size:	127.5 KB ID:	1428589
Working...
X