Announcement

Collapse
No announcement yet.

Dayton Audio kab-250v3 and a Makita 18V battery - need wiring guidance

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dayton Audio kab-250v3 and a Makita 18V battery - need wiring guidance

    Hi,

    After seeing others use a power-tool battery I decided I wanted to try it too. I have the Dayton Audio KAB-250V3 Bluetooth board and it's working fine. I notice that on the right side of the board is a socket for a 4-pin power connector for a battery and the instructions show all 4 pins occupied in the accompanying graphic. If the battery socket I have only has 2 wires coming from it, which 2 sockets on that 4 pin connector should be wired in? I'm guessing the center 2 but wanted to be sure.

    Secondly, where does everyone shop to get the small connectors used with this device? Does Parts Express carry them all? I am specifically looking for the 4-pin power connector.

    Is there anything else I should be thinking about as I'm wiring this all up?

    Cheers
Working...
X