Help please! Error message when attempting to use software for PE DSP Sub amp

[lunchmoney]

So I was all excited to run the GUI software for my shiny new SPA500DSP plate amp, but when I open the software I get the following error:

"This VI is not executable. The full development version of LabVIEW is required to fix the errors."

Anyone know how to fix this?

Thanks

[wogg]

I had the same issue. You need to install the .NET 3.5 package in Windows. Give a little Googling to that and you'll find instructions.

[lunchmoney]

I had the same issue. You need to install the .NET 3.5 package in Windows. Give a little Googling to that and you'll find instructions.

Thanks!

[lunchmoney]

FIXED. Thanks wogg!

[wogg]

No problem... They really should put that requirement in the user documentation. I ended up locating that in the NI documentation somewhere for that runtime they're using for the GUI.

[djg]

So good thing my memory isn't totally shot. New PC, same error message with the 250DSP software.

Thanks all, would have been lost .