Announcement
Collapse
No announcement yet.
Increasing MLTL cabinet thickness, but with same Design Volume?
Collapse
X
-
The advertised response of the 4 ohm looks like they will require less BSC than most drivers. They would likely end up 80-82db when implemented, which is pretty much typical for 6-7" 2-ways.
-
Increasing MLTL cabinet thickness, but with same Design Volume?
I'm about ready to mill some birch for the Triton MLTL speakers. The plans call for 3/4" thick matrl. I want to go 1-1/4" or 5/4 as I like to call it. I know my baffle width has to be the same, so to increase the extra volume can I just go with a deeper cabinet, so that the end results has the same volume as the orig. design.
Also, I want to use a little bit different vent size since I have this awesome extra thick HDPE pipe, that's 2-13/6" ID. Can I just plug these numbers into WinISD Pro to get the correct length of vent? I'll double check the speed for chuffing.
Thanks in Advance for your helpTags: None
Leave a comment: