Announcement

Collapse
No announcement yet.

Daft question - driver orientation

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ugg10
    commented on 's reply
    Thanks, I put my mid/tweeter screws top to bottom, maybe a bad choice but heho I will live with until I get the urge to remake the box (currently re-using Akai SW125 boxes).

  • DeZZar
    commented on 's reply
    Yeah, this is where I landed: https://techtalk.parts-express.com/f...5&d=1657702979

  • Ugg10
    commented on 's reply
    Many thanks, that was my suspicion but thought I’d double check, thanks for taking the time to answer. The 9 holes (not 8) on the WO24P are a challenge aesthetically with the 6 holes for the mid/tweeter !

  • DeZZar
    replied
    That's fine. There is no right or wrong way - you can mount them however you like. I focus on the aesthetics of the bolt holes and consider where my wiring will be coming from for the terminals.

    Leave a comment:


  • Ugg10
    started a topic Daft question - driver orientation

    Daft question - driver orientation

    Daft question but thought I’d double check before making a mistake.

    Just about to install a SB WO24P, Morel EM1308 and Morel ET448 in my cabinets. I am planning on installing them as follows-

    WO24P - -be terminal at 9 o’clock, +be terminal at 3 o’clock when viewed from rear
    EM1308 and ET448 - terminals at 6 o’clock when viewed from rear.

    Is there a preferred orientation or is this Ok?
Working...
X