Announcement

Collapse
No announcement yet.

New User Friendly Transmission Line Modeler

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • New User Friendly Transmission Line Modeler

    Anyone here use this yet? Impressions?

    http://www.leonardaudio.co.uk/software/publish.htm

    It looks like another version of the "sectional" approach.

  • #2
    Re: New User Friendly Transmission Line Modeler

    Seems to work pretty well for standard TLs. Certainly is easier than others I've tried. Placing the speaker part-way down the line is a bit awkward, though. You have to adjust the length of two "elements", then that messes up the taper.

    Not so sure about modeling BRs, it seems to want a longer port than, say, WinISD expects.

    From the thread on DiyAudio, it seems like it's still in Alpha. I'd say he's off to a good start.

    Comment


    • #3
      Re: New User Friendly Transmission Line Modeler

      Hi,

      I'm Pete Leonard and this is my software that I have been working on over the past few months. As Jef has said, this program is very much still in development stages. On that note, if you have any requests/suggestions/comments then please do send them over to me at [email protected] I will also check back here occasionally.

      Thanks,
      Pete

      Comment

      Working...
      X