RS-P WWMTM 3 Way underway ( pic heavy )

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

thats what i'm screaming !

[joeybutts]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

bwhahhahaha. thankfully it goes IN the cabinet. :p

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

like i said , not pretty ...

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

it ain't pretty but i am confident its right ... almost got the first one done .

[joeybutts]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

looks good to me

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

Are you going to solder it?

yes

[Adam_G]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

hmmm ...

this will probably be the last time its seen . i'm just worried about it working right ...

inductor spacing is good though ?

Are you going to solder it?

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

hmmm ...

this will probably be the last time its seen . i'm just worried about it working right ...

inductor spacing is good though ?

[joeybutts]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

no idea as far as correct. As far as aesthetics, I would have pulled the leads through the pegboard and connected all underneath...like so -

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

anyone see any glaring issues before i start soldering ?

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

got to town (slow at work) and got a 4' x 4' piece of pegboard . wasn't bad , $12 ...

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

thanks for the schematic Josh ...

I'd suggest pegboard and zip ties instead.

i think your right . i took a good look at everything last night and 1) these circuit boards are kinda small 2) i'd probably just end up drilling a bunch of holes anyways.

pegboard isn't really local though , will have to go into town this weekend ...

[jbruner]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

[rpb]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

you can count on it Rory ! Thanks again for handling the tweeter issue ...

this is where i tend to run outta steam during my builds , they are together in place and being used . i find it hard to get motivated and get the finish done .

today i went to the Shack and got some circuit boards so i no longer have an excuse not to get the XO's together , tho i have to admit my lack of experience in putting XO's together does have me a lil concerned as these do deserve some good work ...

I'd suggest pegboard and zip ties instead.

[filmslayer]

Re: RS-P WWMTM 3 Way underway ( pic heavy )

i'm gonna try to get it on one board , inside my bottom foam is space for 7"x9" but the boards i got today are 6 3/4" x 4 3/4" ...