Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
The tweeter measurements were perhaps 1.5” above center, but still in line with the top part of the ribbon. I can try some tomorrow that are dead center....
-
I am more than happy to have the help! all 4 woofers are in the same enclosure, the top two are wired in series and the bottom two are wired in series....
-
Yes, they are all take on-axis at approximately 4 feet from the baffle with the mic height slightly higher than the center of the tweeter.
-
Here are the ZMA files - the woofer ZMA is a pair of woofers wired in series....
-
No problem. Here are the files. I'll post the ZMAs in another post....
Leave a comment:
-
Yes, mid is in a sealed enclosure - woofers are in a separate ported enclosure tuned to about 40hz....
Leave a comment:
-
Greetings! I haven't had much time to work on this lately, but was able to take a few new measurements, and play around with a revised XO a bit. I did...
Leave a comment:
-
Thanks everyone. I'll take some individual measurements of the woofers and work on pulling the XO point down. I'll also move the tweeter pad to avoid...
Leave a comment:
-
-
Good Evening!
I've been doing a lot of tweaking with this project over the past few weeks. I've built a few variations that sound (and measure)...
Leave a comment:
-
Here is the FR plot on axis with the padding and a few other adjustments in place. I’ve also included a picture of my mess of a test rig. My wife...
Leave a comment:
-
Greetings!
So I received the crossover components, and wired everything up. It was immediately clear that the midrange and tweeter were...
Leave a comment:
-
below is a tweaked version that cleans up some of the FR issues from the prior post. I have 50% of the components to build this crossover already laying...
- Likes 1
Leave a comment:
No activity results to display
Show More
Leave a comment: