aarond
Seasoned Veteran
Last Activity: Today, 12:56 AM
Joined: 10-26-2005
Location:
-
Have you done a complete print at .1 and .3 layer heights to compare the difference on the top layers? With PLA and a .4 nozzle I did a similar part both... -
That's a beautiful thing....Leave a comment:
-
That sums things up nicely, thank you again
Out of curiosity I might try to see what the response looks like when modeled in the small factory...Last edited by aarond; 09-13-2022, 04:02 PM.Leave a comment:
-
This screen shot is a quick and dirty I did in WinISD using only Qts, Vas and Fs derived with the WT3. The volume and tuning was done with default suggestions....
Last edited by aarond; 09-12-2022, 08:40 PM.Leave a comment:
-
Much appreciated man. The DCR of that coil does appear to be in the neighborhood of 1-1.1ohms. The sweep in the pic is free air (sitting on my dining...Leave a comment:
-
Here's a pic of the WT3 sweep. R(e) is 4.3 ohms, not sure what it would be after the 2.4mH coil is inserted. I can measure the DCR of the coil later tomorrow/...
Leave a comment:
-
Need some crossover schematic interpretation
I'm really only concerned with the midbass circuit but I don't have the knowledge to interpret it.
For reference this is an Infinity IL60... -
Just to follow up somewhat... my WT3 seems to be pretty finicky but, luckily, I can get it to do what I need running Windows 10 and the DATS software....Leave a comment:
-
I think I got it. After some more inexperienced weirdness I had to do some more form searching. I'm running the DATS V2 software (should've mentioned...Leave a comment:
-
Is my WT3 hosed?
I'm not sure what the calibration curves are supposed to look like but surely someone here does. I purchased this 10ish years ago off of the PETT classifieds....
No activity results to display
Leave a comment: