Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Great question... no idea. That's probably a potential improvement, I was getting direction from a Vituix guru at that point so that decision falls into...
-
Another section of write up is available on my Wogg page.
http://woggmusic.com/anarchies-crossover-design/
This outlines the...
- Likes 1
Leave a comment:
-
Finally, and what I find super interesting is the +-90 degree directivity plot. This shows the effect of the symmetrical tilt to the driver centers with...
- Likes 2
Leave a comment:
-
Lastly, I did a full -90 to +90 degree sweep in similar 30 degree increments in the same space I did the original individual driver measurements for design....
- Likes 1
Leave a comment:
-
The first thing I did was a simple REW measurement at the listening point, ungated with both speakers driven. This is through an older Yamaha Aventege...
- Likes 1
Leave a comment:
-
It's been a minute since these debuted at inDIYana, let's wrap this thing up. Final position: The simulation values were used to build the final product,...
- Likes 1
Leave a comment:
-
First standard response: The location under your mains is very rarely the best place for a sub. Aesthetically good, not necessarily acoustically good....
Leave a comment:
-
Is JLCPCB really that cheap, provided you can create your own gerbers? Only $2 for a 100mm square 2 layer seems crazy cheap!
I've only used...
Leave a comment:
No activity results to display
Show More
Leave a comment: