Correct. Speakers operate on AC, alternating current. The + and - on the XO diagrams are to show how the amp power is input.
The speaker...
djg
Seasoned Veteran
Last Activity: Today, 12:53 AM
Joined: 05-31-2008
Location: wisconsin
-
-
-
Leave a comment:
-
Maybe it's time to design your own.Leave a comment:
-
Meniscus made these for me. They have nice terminals in and out, but they aren't necessary. The tape covers component values of a proprietary design....
Leave a comment:
-
The only part that might be confusing is on the LH side of the schematic where wires cross without little dots. That means they are not...Leave a comment:
-
The XOs are pretty simple. I would make 3 separate boards. I would make them big enough so that I could lay all the parts out just as they are drawn....Leave a comment:
-
CNC is hard to beat. Looks great. -
You are saving a lot of money, wood is very expensive lately. -
Awesomely frugal. -
# braces. Are you happy with that plywood? Is it lighter than MDF? -
Are those brass screws mounting the big coil? -
I use epoxy (Bob Smith Industries) to attach XO components to board. I've had hot glue fail a shipping test. Foam sticky tape I've found the foam itself...Last edited by djg; 08-09-2022, 04:53 PM. -
Cheapster here. WalMart quilt batting worked for me in my Econowaves. -
This is a very similar size design. It shows two transverse dowels, I built mine with one particle board brace about 3/4" x 3". They sound fine...
Leave a comment:
-
That's pretty impressive to a table saw/plunge router guy like me.
One question, do you have the components in hand to double check the cutout...Leave a comment:
-
Try extruding this through your criteria filter. I built a pair of ported as 2.1 satellites, very pleased for about $100. Crossed at 80 with a Dayton...Leave a comment:
-
Leave a comment:
-
What happened?Leave a comment:
No activity results to display
Leave a comment: