Tweet
About 10 minutes. I'd guess. I use my knife and trim immediately after I get done with the panel. I use a rubber mallet to make sure the edges are firmly stuck. I use a sanding block for the final edge. I think I'd wrap/layout a couple layers of tape with a router and leave it a little proud, then sand. Just put contact cement on the panels you are working -- not the whole box. You'll never get all the little bits off.
-
Lou's Speaker Site [speakers.lonesaguaro.com]
"Different" is objective, "better" is subjective. Taste is not a provable fact.
Where are you John Galt? I may not be worthy, but I'm ready.